nije li problem da mi pojasnis malo sta ja trebam da uradim.
ne razumem se bas u mreze i ne znam koji me djavo terao da cackam ali sta cu sad.
eth0 IP?gde to da ukucam
stavio sam ip da je 192.168.100.10
subnet mask 255.255.255.0
a sta da pokusam kod gateway-a trenutno mi je default 192.168.100.252
preferred DNS 192.168.100.252
trazio sam nesto po netu i naso Read me (realap-0.2.5-ovis)
evo ga:
RealAP: Realtek 8181 GPL firmware (mini distro)
===================================================================
Copyright Tom Vrana <tom at voda dot cz>
This software is provided under the term of GNU Public Licence (GPL). For
more info see COPYING.
IMPORTANT: this release is proof of concept - while I believe that it should
be stable and usable, I do not guarantee its fitness for any purpose.
important files
---------------
/etc/runtime - configuration directory, its contents are saved via
wrunt/rrunt commands to flash
main.cfg - just specify what should be started - this file is used by
/etc/init.d/rcS that starts everything else
interfaces - which interfaces should be configured
nat - which interface should be masqueraded
wlan - WLAN parameters
bridge - which interfaces should be added to bridge
def_route - default route
user - you can put any additional commands here
ifcfg/ - contains configuration of respective interfaces
route/ - contains routing information files TEMPLATE included
/etc/init.d/ - this directory contains startup scripts for different
services, their usage follows typical UN*X init.d
available important commands
----------------------------
ip, tc, iwconfig, iwlist, iptables, netperf, wget, ftpput, ftpget
wrunt - save /etc/runtime contents to flash
rrunt - restore /etc/runtime
flw - write firmware image to flash from offset 0x10000
firmare upgrade/change
----------------------
As there is no web interface in this version, you need to use wget to
dowlnoad the firmware from you webserver and then save it using flw:
cd /tmp
wget
http://192.168.2.2/firmware.bin
flw firmware.bin
reboot
That's it - if you upgraded to newer version of our firmware, you get to
keep the configuration (this may change in the future)
some defaults
-------------
To reset device's default config unplug power, plug again and hold reset
switch for about 30 second. This does not erase the flash contents, you
configuration stays stored, if you login via ssh, you can restore it and
check (using rrunt). Until you do a wrunt / save config no changes to flash
occur.
wlan0 is 192.168.3.1/24
eth0 is 192.168.2.1/24 - if you have more than one ethernet port (WA2104 ex
and the like) only one port will be active, you need to configure them later
ssh access is root/ochrana, four simultaneous logins allowed
Tom Vrana < tom at voda dot cz>
Hvala unapred..